AMS 5510
Aerospace flat-product specification for SS321. Review the material identity, supply condition and reference properties before preparing an enquiry.
SS321 Sheet, Strip & Plate
AMS5510T
1 linked material grade
Material requirements.
Clearly organized.
Aerospace flat-product specification for SS321. Review the material identity, supply condition and reference properties before preparing an enquiry.
Solution heat treated; verify thickness, finish and ordered revision.
Find your material grade
Open a material page or switch between chemical composition and mechanical properties.
Chemical & Mechanical Properties
Select a table to compare the source-labelled material data.
| Grade / identification | C % | Cr % | Ni % | Mo % | Other |
|---|---|---|---|---|---|
| SS321 S32100 | 0.04 | 17.3 | 9.1 | — | Ti stabilized |
Manufacturer typical composition, mass %; selected elements only.
These published alloy values are comparison data. The AMS 5510 acceptance limits must be checked in the specified revision.
| Grade / identification | Product form / condition | Tensile (MPa) | 0.2% proof / yield (MPa) | Elongation (%) | Data basis |
|---|---|---|---|---|---|
| SS321 S32100 | Hot-rolled plate, usually 10–20 mm, transverse; room temperature | 570 | 250 | 55 | Manufacturer typical values; elongation A5. |
Typical properties are comparison values. Manufacturer limits marked “min” apply only to the stated product. Confirm the ordered revision, thickness, heat treatment, specimen direction and gauge length before material acceptance.
Engineered for demanding service.
Grade selection depends on the process environment, temperature, corrosion exposure and equipment design.
From material specification to gasket construction
Select the required product form, grade, delivery condition and certification for the approved gasket construction. Finished gasket dimensions and performance requirements are established separately.
Explore gasket products ↗Common questions
Short answers for engineers and purchasing teams.
How should AMS 5510 be specified?
State the revision, exact material grade, product form, dimensions, delivery condition and certification requirements on the purchase order.
Are the displayed properties specification acceptance limits?
The tables identify published manufacturer reference data. Typical values describe the stated reference product and are not certified AMS 5510 limits. Use the ordered revision for material acceptance.
Are these all the materials covered by the standard?
This page links selected materials already present on the website. The linked material list is not the complete scope of the standard.
Which sources support this material reference?
Parker Aerospace — controlled specification list (AMS forms and conditions)
Outokumpu — Steel Grades, Properties and Global Standards, Tables 4, 5 and 7