AMS 5870
AMS5870G covers Alloy 601 flat products from 0.25 to 50.80 mm nominal thickness.
Alloy 601 Sheet, Strip & Plate
AMS5870G (2024)
1 linked material grade
Material requirements.
Clearly organized.
AMS5870G covers Alloy 601 flat products from 0.25 to 50.80 mm nominal thickness.
Solution heat treated.
The AMS title includes titanium in the nominal chemistry. The general Alloy 601 bulletin below is not a complete AMS5870 chemistry table.
Find your material grade
Open a material page or switch between chemical composition and mechanical properties.
Chemical & Mechanical Properties
Select a table to compare the source-labelled material data.
| Grade / identification | Ni % | Cr % | Al % | Fe % | C % |
|---|---|---|---|---|---|
| Alloy 601 N06601 | 58.0–63.0 | 21.0–25.0 | 1.0–1.7 | Remainder | 0.10 max |
Manufacturer alloy composition limits, mass %; selected elements only. These are not the complete acceptance limits of the standard on this page.
These published alloy values are comparison data. The AMS 5870 acceptance limits must be checked in the specified revision.
| Grade / identification | Product form / condition | Tensile (MPa) | 0.2% proof / yield (MPa) | Elongation (%) | Data basis |
|---|---|---|---|---|---|
| Alloy 601 N06601 | 1.57 mm cold-rolled sheet, solution treated at 1180 °C; room temperature | 686 | 301 | 47 | Manufacturer typical test result; not a guaranteed minimum. |
Typical properties are comparison values. Manufacturer limits marked “min” apply only to the stated product. Confirm the ordered revision, thickness, heat treatment, specimen direction and gauge length before material acceptance.
Engineered for demanding service.
Grade selection depends on the process environment, temperature, corrosion exposure and equipment design.
From material specification to gasket construction
Select the required product form, grade, delivery condition and certification for the approved gasket construction. Finished gasket dimensions and performance requirements are established separately.
Explore gasket products ↗Common questions
Short answers for engineers and purchasing teams.
How should AMS 5870 be specified?
State the revision, exact material grade, product form, dimensions, delivery condition and certification requirements on the purchase order.
Are the displayed properties specification acceptance limits?
The tables identify published manufacturer reference data. Typical values describe the stated reference product and are not certified AMS 5870 limits. Use the ordered revision for material acceptance.
Are these all the materials covered by the standard?
This page links selected materials already present on the website. The linked material list is not the complete scope of the standard.
Which sources support this material reference?
Special Metals — INCONEL alloy 601 technical bulletin, Tables 1 and 8